Contact Us
ASK OUR EXPERTS +44 (0) 2380 457747 Home Mal's-E: View Cart
Battery Isolators & Accessories Power Distribution Wireless Control System FiA Rain Lights Coolant Level Sensors Shift Lights Digital Gear Indicators LiteBlox Batteries Speedo Converters Fog Light Switch Controls

LIKE US ON FACEBOOK

 © 2017 Cartek Automotive Electronics Limited. All Rights Reserved.






CARTEK NEWSLETTER

Subscribe and get our latest news, product releases and latest guides.



CONTACT

CARTEK AUTOMOTIVE ELECTRONICS LTD


Unit 25, Mitchell Point

Ensign Way, Hamble

Southampton, SO31 4RF

United Kingdom


Tel: +44(0)2380 457747

Email: sales@cartekmotorsport.com

CARTEK LINKS

Click here for KMH-MPH Converters, Fog Light Controls and much more for the JDM Imports market



Click here for Solid State Battery Isolators, FiA Rain Lights and much more for the Motorsport industry.


SECURE SHOPPING PRICES EXCLUDE VAT + SHIPPING HOSTED BY PRODUCTS

INCLUDES:  

1 x CAN BUS SIGNAL CONVERTER







OBD 2 CAN BUS SIGNAL CONVERTER

£88.25 EX VAT

INTRODUCTION


Many aftermarket car accessories such as Gear Shift Lights, Tachometers or Digital Gear Displays require connection to electrical signals which are often not available on modern cars. The CAN-Bus Signal Converter from CARTEK simply plugs into the OBD (On Board Diagnostic) socket found on most modern cars and provides four useful signals by extracting and converting engine data from the car's CAN-Bus network.


INSTALLATION


Locate the car's OBD2 socket which will be within 60cm (2ft) of the steering wheel. Insert the CAN-Bus Signal Converter then start the engine. If this is the first time the CAN-Bus Signal Converter has been installed then it may take a short while for it to interrogate the car's CAN-Bus network and synchronize to the correct protocol. This will be indicated by a Red LED.

Once the correct protocol has been determined then engine data will be extracted from the CAN-Bus network and converted into output signals. This will be indicated by a flashing Green LED.  


OUTPUT SIGNALS


RPM (Blue wire)

This is a 12v square wave signal where the frequency increases with engine speed. The signal outputs 2 pulses per crankshaft revolution

SPEED (Green wire)

This is a 12v square wave signal where the frequency increases with road speed. The output frequency is approximately 2500 pulses per kilometer (1570 pulses per mile).

ENGINE RUNNING (Grey wire)

This signal remains high (+12v) when the engine is stationary and is driven low (0v) when engine speed exceeds 350RPM.

VEHICLE TRAVELING (Yellow wire)

This signal remains high (+12v) when the car is stationary and is driven low (0v) when road speed exceeds 9 Km/h (6mph).



PART NO: CK-CC-04

QUANTITY

For more information go to: www.cartekmotorsport.com